To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Measuring Frequency

Special Tools

EL-39200 Digital Multimeter (DMM)

For equivalent regional tools, refer to Special Tools .

Caution: Refer to Test Probe Caution in the Preface section.

The following procedure determines the frequency of a signal.

Note: Connecting the Digital Multimeter (DMM) to the circuit before pressing the Hz button will allow the DMM to autorange to an appropriate range.

  1. Apply power to the circuit.
  2. Set the DMM to the V (AC) position.
  3. Connect the positive lead of the DMM to the circuit to be tested.
  4. Connect the negative lead of the DMM to a good ground.
  5. Set to Hz on the DMM.
  6. The DMM will display the frequency measured.
   


© Copyright Chevrolet. All rights reserved
   


© Copyright Chevrolet. All rights reserved