To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

ABS Indicator Malfunction

Diagnostic Instructions

    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Circuit/System Description

The instrument cluster turns ON the ABS indicator for 5 seconds after ignition ON or when the electronic brake control module detects a fault and sends a serial data message to the instrument cluster commanding the indicator ON.

Reference Information

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

ABS Description and Operation

Electrical Information Reference

    •  Circuit Testing
    •  Connector Repairs
    •  Testing for Intermittent Conditions and Poor Connections
    •  Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

  1. Ignition ON.
  2. Verify the instrument cluster ABS indicator turns ON and OFF when commanding the All Indicators ON and OFF with a scan tool.
  3. ⇒   If the ABS indicator does not turn ON and OFF
        Replace the P16 instrument cluster.
    ⇓   If the ABS indicator turns ON and OFF
  4. Verify the ABS indicator turns OFF 5 seconds after the ignition is turned ON.
  5. ⇒   If the ABS indicator does not turn OFF
        Replace the K17 electronic brake control module.
    ⇓   If the ABS indicator turns OFF
  6. All OK.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the repair.

Control Module References for electronic brake control module or instrument cluster replacement, programming and setup

   


© Copyright Chevrolet. All rights reserved
   


© Copyright Chevrolet. All rights reserved