Orlando

DTC C0280

The solenoid valves are integral parts of the brake pressure modulator valve assembly. The brake pressure modulator valve assembly contains an isolation solenoid valve and a dump solenoid valve for each wheel and a traction control/stability control supply solenoid valve and isolation solenoid valve for each brake circuit. The solenoid valves are not engaged during normal system operation. When the ABS, traction control or stability control operation is required the Electronic Brake Control Module turns the required solenoid valves ON.

Ignition ON.

Stability control is active for more than 15 s.

The condition for setting the DTC is no longer present.

DTC can set because of extended operation of ABS, traction control or stability control.

Schematic Reference

Antilock Brake System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

ABS Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

Note: Since most occurrences of this DTC are caused by excessive ABS or traction usage, review with the customer the conditions under which the DTC set.

1. Ignition ON.
2. Verify that DTC C0186, C0196, C019B, or C0710 is not set.

⇒	If any listed DTC is present

Refer to Diagnostic Trouble Code (DTC) List - Vehicle to diagnose that DTC prior to this diagnostic.

⇒	If DTC C0280 00 is set

Refer to Circuit/System Testing.

⇓	If DTC C0280 00 does not set

3. All OK.

1. Ignition ON.
2. If DTC C0280 00 is set, replace the K17 Electronic Brake Control Module.
3. Verify that the DTC does not set.

⇒	If the DTC C0280 00 sets

Replace the brake pressure modulator valve assembly.

⇓	If the DTC C0280 00 does not set

4. All OK.

Perform the Diagnostic Repair Verification after completing the repair.