Orlando

Radiator Inlet Hose Replacement - LDE, LGE, LLU, LXV, 2H0, LUW and LFH

1. Disconnect the battery. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .
2. Unclip the engine control module, if necessary.
3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
4. Place a drain pan below the vehicle.
5. Drain the cooling system. Refer to Cooling System Draining and Filling .



6. Loosen the radiator inlet hose clamp (2).
7. Remove the radiator inlet hose (3) from the radiator (1).
8. Loosen the radiator inlet hose clamp (4).
9. Remove the radiator inlet hose (3) from the thermostat housing (5).

1. Install the radiator inlet hose (3) to the thermostat housing (5).
2. Install the radiator inlet hose clamp (4).
3. Install the radiator inlet hose (3) to the radiator (1).
4. Install the radiator inlet hose clamp (2).
5. Lower the vehicle.
6. Fill the cooling system. Refer to Cooling System Draining and Filling .
7. Clip in the engine control module, if necessary.
8. Connect the battery. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .