1

Did you review the Steering Wheel and Column Description and perform the necessary inspections?

Go to Step 2

Go to Steering Wheel and Column Description and Operation

Verify that noise is present in the steering column during operation.

Is noise present in the steering column during operation?

Go to Step 3

System OK

Inspect the steering column mounting features for the following conditions:

Are the steering column mounting features loose?

Go to Step 8

Go to Step 4

Inspect the SIR/SRS coil for noise.

Is the SIR/SRS coil noisy?

Go to Step 09

Go to Step 5

Inspect the lock plate retaining ring for correct installation.

Is the lock plate retaining ring installed incorrectly?

Go to Step 10

Go to Step 6

Inspect the steering column upper and lower bearings for the following conditions:

Are the bearings in need of repair or replacement?

Go to Step 11

Go to Step 7

Note: This is best evaluated while driving the vehicle, turning the steering and applying the brake pedal.

Inspect the intermediate steering shaft for noise.

is the intermediate steering shaft noisy?

Go to Step 12

Go to Step 13

Note: If the steering column mounting is damaged or sheared, the steering column will need to be replaced. Refer to Steering Column Replacement

Tighten the steering column mounting fastener to specifications. Refer to Fastener Tightening Specifications

Did you complete the repair?

Go to Step 13

—

Replace the SIR/SRS coil. Refer to Steering Wheel Inflatable Restraint Module Replacement

Did you complete the repair?

Go to Step 13

—

Install the lock plate retaining ring correctly.

Did you complete the repair?

Go to Step 13

—

Note: If the steering column upper and/or lower bearings are not serviceable, the steering column will need to be replaced. Refer to Steering Column Replacement

Replace the upper and/or lower bearing, if serviceable.

Did you complete the repair?

Go to Step 13

—

Replace the appropriate intermediate steering shaft component. Refer to Intermediate Steering Shaft Replacement

Did you complete the repair?

Go to Step 13

—

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3