Service Information

Orlando

DTC B3006

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC B3006 01: Hood Ajar Circuit Short to Battery

DTC B3006 02: Hood Ajar Circuit Short to Ground

DTC B3006 04: Bonnet Ajar Circuit Open Circuit

Diagnostic Fault Information

Circuit	Short to Ground	Open/High Resistance	Short to Voltage	Signal Performance
Hood Ajar Switch Signal	B3006 02	B3006 04	B3006 01	--
Ground	--	B3006 04	--	--

Circuit/System Description

The body control module monitors the voltage input of the bonnet ajar switch signal circuit.

Conditions for Running the DTC

The BCM continuously monitors for this DTC

Conditions for Setting the DTC

B3006 01

The BCM detects that the Bonnet Ajar Switch signal circuit is shorted to battery.

B3006 02

The BCM detects that the Bonnet Ajar Switch signal circuit is shorted to ground.

B3006 04

The BCM detects that the Bonnet Ajar Switch signal circuit is open.

Action Taken When the DTC Sets

Prevent an engine start.

Conditions for Clearing the DTC

•	A current DTC will clear when the conditions for setting are no longer present.

•	A history DTC will clear after 40 malfunction free ignition cycles.

Reference Information

Schematic Reference

•	Immobiliser Schematics

•	Remote Function Schematics

•	Theft Deterrent System Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Keyless Entry System Description and Operation : with ATH → without ATH

Electrical Information Reference

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Ignition ON, observe the scan tool BCM Bonnet Ajar Switch parameter. With the bonnet open, the Bonnet Ajar Switch parameter should read open. With the bonnet closed, the Bonnet Ajar Switch parameter should read closed.

Circuit/System Testing

Ignition OFF, disconnect the harness connector at the B55 Hood Ajar Switch.
Ignition OFF, test for less than 5 Ω between the ground circuit terminal C and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

Ignition ON, test for greater 11 V between the signal circuit terminal A and ground.

⇒	If less than the specified range, test the signal circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.

If all circuits test normal, test or replace the B55 Bonnet Ajar Switch.

Component Testing

Static Test

Ignition OFF, disconnect the harness connector at the B55 Hood Ajar Switch.
With the B55 Bonnet Ajar Switch open position, test for infinite resistance between the ground terminal C and the signal terminal A.

⇒	If not infinite, replace the B55 Bonnet Ajar Switch.

With the B55 Bonnet Ajar Switch closed position, test for less than 5 Ω between the ground terminal C and the signal terminal A

⇒	If greater than the specified range, replace the B55 Bonnet Ajar Switch.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for BCM replacement, programming and setup