To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Braking Action Uneven -- Pulls to One Side

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. Suspension components that are not operating properly may cause a disturbance to the vehicle during application of the brake system.

  2. Steering components that are not operating properly may cause a disturbance to the vehicle during application of the brake system.

Step

Action

Yes

No

DEFINITION: Vehicle pulls to one side only when braking.

1

Were you sent here from the Hydraulic Brake Symptom table?

Go to Step 2

Go to Symptoms - Hydraulic Brakes

2

  1. Inspect the hydraulic brake system for the following conditions.
  2. • Kinked, pinched or damaged brake pipe or flexible brake hose
    • Sticking or improperly operating calliper piston
    • Brake fluid leak
  3. Adjust, repair or replace components as necessary. Refer to Hydraulic Brake System Diagnosis .

Did you find and correct a condition?

Go to Step 6

Go to Step 3

3

  1. Inspect the disc brake system for the following conditions.
  2. • Contaminated linings
    • Glazed linings
    • Distorted, cracked or damaged linings on one side
    • Loose, damaged or missing calliper hardware and/or lining hardware
    • Incorrect linings on one side
    • Hard spots, heat checks, blueing discolouration of rotor friction surfaces; possibly due to brake drag
    • Glazed rotor friction surfaces
    • Bent or damaged calliper or mounting component
  3. Adjust, repair or replace components as necessary. Refer to Disc Brake System Diagnosis .

Did you find and correct a condition?

Go to Step 6

Go to Step 4

4

  1. Inspect the suspension system for the following conditions.
  2. • Incorrect tyre pressures
    • Loose suspension component connections
    • Excessively worn or damaged suspension components
  3. Adjust, repair or replace components as necessary.

Did you find and correct a condition?

Go to Step 6

Go to Step 5

5

  1. Inspect the steering system for the following conditions.
  2. • Loose steering component connections
    • Excessively worn or damaged steering components
  3. Adjust, repair or replace components as necessary. Refer to Symptoms - Power Steering System : Hydraulic Power Steering  → Electronic Power Steering .

Did you find and correct a condition?

Go to Step 6

Go to Symptoms - Hydraulic Brakes

6

  1. Install or connect components that were removed or disconnected during diagnosis.
  2. Road test the vehicle in order to confirm proper operation. Refer to Brake System Vehicle Road Test .

Is the condition still present?

Go to Step 2

System OK

   


© Copyright Chevrolet. All rights reserved
   


© Copyright Chevrolet. All rights reserved