Orlando

Drive Belt Installation

Special Tools

EN-6349 Locking Pin

For equivalent regional tools, refer to Special Tools .

1. Install the drive belt (1).




Note: Make sure that the drive belt is aligned on the alternator pulley (4), crankshaft balancer (5), drive belt tensioner (6) and water pump pulley (7). The drive belt must lie on the water pump pulley between the flange (1) and (2).

2. Check the position of the drive belt (3).



3. Release tension to the tensioner anti-clockwise (1).

Note: Allow tensioner to slide back slowly.

4. Remove EN-6349 pin (2).
5. Apply tension to the tensioner at projection (1) clockwise.