Orlando |
||||||||
|
|
|
|||||||
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
If the tyre pressure sensor learn procedure has not been performed, the tyre pressure monitor system indicator icon on the instrument cluster will flash for 1 min. and then remain illuminated after the ignition switch is cycled ON and the instrument cluster bulb check is complete. If equipped, the driver information center will also display a service tire monitor type message. Under these circumstances, DTC C0775 will be set and the tire pressure sensor learn procedure will need to be performed for the system to function correctly.
Ignition ON
The body control module (BCM) has not undergone the tyre pressure sensors learn procedure.
| • | The tire pressure monitor system indicator icon on the instrument cluster will flash for 1 min. and then remain illuminated after the ignition switch is cycled ON and the instrument cluster bulb check is complete. |
| • | If equipped, the driver information center displays a service tire monitor type warning message. |
A current DTC will clear when the BCM has undergone the tyre pressure sensor learn procedure and 1 ignition cycle has occurred.
Tyre Pressure Monitor Description and Operation
Control Module References for scan tool information
Verify that the DTC C0569 or DTC C0775 is not set.
| ⇒ | If the DTC is set, perform the Body Control Module (BCM) Tyre Pressure Sensors Learn with the scan tool and cycle the ignition. If the DTC resets, replace the K9 Body Control Module. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References - for BCM replacement, setup, and programming
| © Copyright Chevrolet. All rights reserved |
| © Copyright Chevrolet. All rights reserved |
