Orlando

DTC P080A

The clutch pedal position (CPP) is a three wire sensor, connected to a 5 V reference circuit, a low reference circuit, and a signal circuit. The engine control module (ECM) supplies 5 V to the CPP sensor, and also provides a sensor ground path on the low reference circuit. The CPP sensor sends a voltage signal to the ECM on the signal circuit. The voltage on the signal circuit will vary from a voltage less than or equal to 5 V when the clutch pedal is released to a voltage less than or equal to 1.5 V when the clutch pedal is applied.

Clutch pedal fully applied.

Clutch pedal position not learned.

DTC P080A is a Type B DTC.

DTC P080A is a Type B DTC.

Schematic Reference

Manual Transmission Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Transmission System Description and Operation

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Engine Control Module Scan Tool Information : LNP → LDE or 2H0

Perform the clutch pedal position sensor learn procedure. Refer to Clutch Pedal Position Sensor Learn .

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.