To the top of the document
Orlando
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Tailgate Emblem/Nameplate Replacement - Orlando


2505500

Callout

Component Name

1

Liftgate Emblem

Caution: Refer to Exterior Trim Emblem Removal Caution in the Preface section.

Procedure

  1. The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
  2. Use a heat gun or equivalent to remove the old nameplate. Clean all adhesive from the rear compartment panel and wipe the surface dry with a clean lint-free towel prior to installing the new emblem.
  3. When removing protective liners from the adhesive tape, be careful not to touch tape with hands and DO NOT allow tape to come in contact with dirt or any foreign matter prior to adhesion.
  4. Close the rear compartment lid prior to adhesion.
  5. Using the palm of the hand, wet out the emblem to the rear compartment lid to ensure full adhesion of the emblem is made.
   


© Copyright Chevrolet. All rights reserved
   


© Copyright Chevrolet. All rights reserved