Orlando

Exhaust Gas Recirculation Pipe Replacement

1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
3. Remove front compartment insulator. Refer to Front Compartment Insulator Replacement .



4. Remove the 4 exhaust gas recirculation bolts (3).
5. Remove the exhaust gas recirculation pipe (2) along with the gaskets (1, 4).

Note: Clean the sealing surfaces.

1. Install the exhaust gas recirculation pipe (2) along with NEW gaskets (1, 4).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the 4 exhaust gas recirculation bolts (3) and tighten to 10 N·m (89 lb in).
3. Install front compartment insulator. Refer to Front Compartment Insulator Replacement .
4. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
5. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection : without Start/Stop System .