Service Information

Orlando

DTC B096A

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC B096A 01: Hazard Lamps Switch Backlight Circuit Short to Battery

DTC B096A 02: Hazard Lamps Switch Backlight Circuit Short to Ground

DTC B096A 04: Hazard Lamps Switch Backlight Circuit Open

Diagnostic Fault Information

Circuit	Short to Ground	Open/High Resistance	Short to Voltage	Signal Performance
Interior Backlighting Control	B096A 02**	B096A 04**	B096A 01*	-
* Hazard Backlighting at Full Intensity and Cannot be Dimmed ** Hazard Backlighting do Not Illuminate

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

Interior Backlighting Control

B096A 02**

B096A 04**

B096A 01*

* Hazard Backlighting at Full Intensity and Cannot be Dimmed

** Hazard Backlighting do Not Illuminate

Circuit/System Description

The body control module (BCM) supplies a voltage reference through the instrument panel cluster dimming voltage reference circuit to the instrument panel cluster lamps dimmer switch, which is part of the headlamp switch. When the dimmer switch is placed in a desired brightness position, reference voltage is applied through the dimmer switch rheostat and the cluster lamps dimmer switch signal circuit to the BCM. The BCM interprets this voltage signal, then applies a pulse width modulated (PWM) voltage to the LED dimming supply circuit to all related interior lamps, illuminating them to the desired level of brightness.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

B096A 01

The BCM detects a short to battery on the LED backlight lamp control circuit.

B096A 02

The BCM detects a short to ground on the LED backlight lamp control circuit.

B096A 04

The BCM detects an open circuit on the LED backlight lamp control circuit.

Action Taken When the DTC Sets

The BCM will not dim or illuminate any LED backlighting supplied by the backlight lamp control circuits.

Conditions for Clearing the DTC

•	The condition responsible for setting the DTC no longer exists.

•	A history DTC will clear once 100 consecutive malfunction ignition cycles have occurred.

Reference Information

Electrical Information Reference

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Ignition ON, vary the interior backlighting from dim to full bright by using the dimmer switch. The interior backlighting should dim and then become full bright.

Circuit/System Testing

Ignition OFF, disconnect the harness connector at the S26 Hazard Warning Switch.
Test for less than 5 Ω between the ground circuit terminal 3 and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

Connect a diode test lamp between the backlight control circuit of the S26 Hazard Warning Switch terminal 2 and ground.
Ignition ON, vary the interior lamp dimming switch from dim to full bright. The test lamp should dim and then become full bright.

⇒	If the test lamp cannot be dimmed, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 Body Control Module.

⇒	If the test lamp is always OFF, test the control circuit for open/high resistance or short to ground. If the circuit tests normal, replace the K9 Body Control Module.

If all circuits test normal, replace the S26 Hazard Warning Switch.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

•	Hazard Warning Switch Replacement

•	Control Module References for BCM replacement, setup, and programming