Orlando

Power Outlet Receptacle Malfunction

The vehicle is fitted with a cigarette lighter and with up to two 12 V accessory power receptacle. The front accessory power receptacle and cigarette lighter are operational when the ignition is turned to either the On or the Accessories positions. The rear accessory power receptacle is connected to B+. To operate the cigarette lighter, press in the lighter knob. When the element is hot, the lighter automatically pops out and is ready for use.

Schematic Reference

Cigar Lighter/Power Outlet Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Power Outlets Description and Operation : 12V

Electrical Information Reference

Special Tools

BO 48871 Cigar Lighter Socket Remover

For equivalent regional tools, refer to Special Tools .

1. Ignition OFF, disconnect the harness connector at the appropriate X80 Accessory Power Receptacle or E32 Cigarette Lighter Receptacle.
2. Test for less than 5 Ω between the ground circuit terminal C and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

3. Verify that a test lamp illuminates between the voltage circuit terminal A and ground.

⇒	If the test lamp does not illuminate, test the voltage circuit for a short to ground or an open/high resistance.

4. Replace the appropriate X80 Accessory Power Receptacle or E32 Cigarette Lighter Receptacle.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.