To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Power Outlet Receptacle Malfunction

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

Diagnostic Fault Information

Circuit

Short to Ground

Open/High Resistance

Short to Voltage

Signal Performance

IGN

1

1

--

--

Ground

--

1

--

--

1. Power Outlet Receptacle Malfunction

Circuit/System Description

The power outlet receptacle or cigarette lighter receptacle is supplied B+ when the ignition is on or in the accessory position.

Circuit/System Testing
  1. Ignition OFF, disconnect the harness connector at the appropriate E32 cigarette lighter receptacle.
  2. Test for less than 5 Ω between the ground circuit terminal C and ground.
    3. ⇒If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal A and ground.
    4. ⇒If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  4. Replace the E32 cigarette lighter receptacle.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    •  Accessory Power Receptacle Retainer Replacement
    •  Accessory Power Receptacle Replacement
   


© Copyright Chevrolet. All rights reserved