Spark

Electronic Brake Control Module Programming and Setup

The following service procedures require either a programming or a setup event performed for a complete repair.

If the electronic brake control module (EBCM) needs to be replaced, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
2. Perform the SPS function Electronic Brake Control Module - Programming and follow the onscreen instructions.
3. Clear DTCs after completing the programming procedure.

If the EBCM needs to be reprogrammed, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
2. Perform the SPS function Electronic Brake Control Module - Programming and follow the onscreen instructions.
3. Clear DTCs after completing the programming procedure.

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, the corresponding procedure must be performed.

Calibrate the steering angle sensor. Refer to Steering Angle Sensor Centreing .

Calibrate the multi-axis acceleration sensor.