To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Mode Valve Link Replacement -- Left-Hand Drive

Removal Procedure
  1. Remove the left side floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Left Side : Right Hand Drive → Left Hand Drive .
  2. Disconnect the mode control cable from the air conditioning (A/C) evaporator and blower module assembly. Refer to Mode Control Cable Replacement : Right-Hand Drive → Left-Hand Drive .
  3. Disconnect the stop lamp switch connector.

    4. 2308737
  4. Remove the mode valve levers (1).

    5. 2309243
  5. Remove the mode valve link screw (1).
  6. Remove the mode valve link (2).

Installation Procedure

    2309243
  1. Install the mode valve link (2).

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the mode valve link screw (1) and tighten to 1.2 N·m (11 lb in).

    3. 2308737
  3. Install the mode valve levers (1).
  4. Connect the stop lamp switch connector.
  5. Connect the mode control cable to the A/C evaporator and blower module assembly. Refer to Mode Control Cable Replacement : Right-Hand Drive → Left-Hand Drive .
  6. Install the left side floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Left Side : Right Hand Drive → Left Hand Drive .
   


© Copyright Chevrolet. All rights reserved