Spark

Crankshaft Balancer Replacement

Special Tools

EN 50175 Crankshaft Locking Device

For equivalent regional tools, refer to Special Tools .

1. Open the bonnet.
2. Raise the vehicle by its full height. Refer to Lifting and Jacking the Vehicle .



3. Remove the compartment splash shield (1).
4. Remove the drive belt. Refer to Drive Belt Replacement .



5. Remove the 3 housing lower plate bolts from the transmission
6. Remove the transmission housing lower plate.



7. Install the EN-50175 crankshaft locking device (1) to lock the crankshaft.
8. Install the bolt (2).



9. Remove the crankshaft balancer bolt (1).
10. Remove the crankshaft balancer (2).

1. Install the crankshaft balancer (2).

Caution: Refer to Fastener Caution in the Preface section.

2. Install the NEW crankshaft balancer bolt (1) and tighten to 85 N·m (63 lb ft).



3. Remove the bolt (1).
4. Remove the EN 50175 crankshaft locking device (1).



5. Install the transmission housing lower plate.
6. Install the 3 housing lower plate bolts to the transmission and tighten to 10 N·m (89 lb in).
7. Install the drive belt. Refer to Drive Belt Replacement .



8. Install the compartment splash shield (1).
9. Lower the vehicle. Refer to Lifting and Jacking the Vehicle .
10. Close the bonnet.