Spark

Crankshaft Front Oil Seal Installation

Special Tools

EN 50172 Crankshaft Front Oil Seal

For equivalent regional tools, refer to Special Tools .

1. Position the NEW crankshaft front oil seal.

1.1.	Position the crankshaft front oil seal in such a way that the engine front cover is over the corresponding cut-out on the cylinder block.

Note: Do not press in the seal ring all the way.

1.2.	Slide the crankshaft front oil seal over the crankshaft. Push, until the crankshaft front oil seal is flush and sits evenly in the cylinder block.

2. Install the EN 50172 crankshaft front oil seal installer (1) to the crankshaft.
3. Tighten the EN 50172 crankshaft front oil seal installer to crankshaft pulley retaining bolt (2).
4. Using the EN 50172 crankshaft front oil seal installer, install the crankshaft front oil seal.
5. Remove the EN 50172 crankshaft front oil seal installer (1).