To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Steering Angle Sensor Centreing

The steering angle sensor does not require centring often. Centreing of the steering angle sensor might be required after certain service procedures are performed. Some of these procedures are as follows:

    •  Electronic brake control module (EBCM) replacement
    •  Steering angle sensor replacement
    •  Steering gear replacement
    •  Steering column replacement
    •  Collision or other physical damage

The steering angle sensor centring procedure can be completed with a scan tool using the following steps:

  1. Using the steering wheel, align the front wheels forward.
  2. Apply the parking brake, or set the transmission in the park (P) position.
  3. Install the scan tool to the data link connector.
  4. Turn the ignition ON, and the engine OFF.
  5. Select Steering Wheel Angle Sensor Reset in the Steering Wheel Angle Sensor Module Control Functions list or in the EBCM Module Setup list.
  6. Follow the scan tool directions to complete the learn procedure.
  7. Select Steering Wheel Angle Sensor Learn in the Steering Wheel Angle Sensor Module Functions list or in the EBCM Module Setup list.
  8. Follow the scan tool directions to complete the learn procedure.
  9. Clear any DTCs that may be set.
   


© Copyright Chevrolet. All rights reserved