Spark

Vehicle Yaw Sensor Learn

The yaw sensor does not require calibration often. Calibration of the yaw rate sensor might be required after certain service procedures are performed. Some of these procedures are as follows:

The yaw rate sensor calibration procedure can be completed with a scan tool using the following steps:

1. Place vehicle on a level surface.
2. Apply the parking brake, or set the transmission in the park (P) position.
3. Install the scan tool to the data link connector.
4. Turn the ignition ON, and the engine OFF.
5. Select Yaw Rate Sensor Reset in the Multi-axis Acceleration Sensor Module Control Functions list.
6. Follow the scan tool directions to complete the calibration procedure.
7. Select Yaw Rate Sensor Learn in the Multi-axis Acceleration Sensor Module Control Functions list.
8. Follow the scan tool directions to complete the calibration procedure.
9. Clear any DTCs that may be set.