To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Adding Keys

Note: 

   • This procedure only learns the vehicle keys. This procedure will not learn the immobilizer function.
   • If the battery voltage is low, charge the battery before programming the control module.
   • A total of 5 keys may be programmed to a single vehicle.
This procedure should be used when a new vehicle key needs to be programmed.

  1. Connect a scan tool to the vehicle.
  2. Insert new key.
  3. Turn on the ignition, with the engine OFF.
  4. Select Module Setup on the immobiliser menu of the scan tool.
  5. Select Additional Key Learn.
  6. Perform key learn according to on-screen instructions.
  7. After completing learn for all of additional key turn on the ignition.
  8. Try to start the engine. If the engine can start, the key coding procedure is successful. If the engine cannot start, it has failed.
   


© Copyright Chevrolet. All rights reserved