Spark

Fuel Gauge Inaccurate or Inoperative

The instrument cluster displays the fuel level based on the information from the engine control module (ECM). The ECM converts the data from the fuel level sensors to a fuel level signal. The ECM sends the fuel level signal via a serial data circuit to the cluster. If the fuel level falls below 11 percent the instrument cluster switches the low fuel level indicator on.

Schematic Reference

Instrument Cluster Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Instrument Cluster Description and Operation

Electrical Information Reference

Scan Tool Reference

Inflatable Restraint Sensing and Diagnostic Module Scan Tool Information

1. Ignition ON, perform the Instrument Cluster Gauge Sweep test with the scan tool, verify that the fuel level gauge sweeps from its low to high position.

⇒	If the fuel level gauge does not sweep, replace the Instrument Cluster.

2. Command the All Indicators test ON and OFF with the scan tool, verify that the low fuel level indicator turns ON and OFF.

⇒	If the low fuel level indicator always stays on or always off, replace the Instrument Cluster.

3. If the fuel level gauge does sweep and the low fuel level indicator changes between ON and OFF, replace the Engine Control Module (ECM).

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References