To the top of the document
Captiva
To Previous PageTo Next Page
GMDE Start PageLoad static TOCLoad dynamic TOCHelp?

SECTION 7

ANNEX

1. RECEIVING INSPECTION

When receiving a new vehicle, Dealer is to inspect it immediately for damage, obvious missing or incorrect part and / or options. This inspection is to be completed before accepting the receipt of vehicle.

2. DIRECTION FOR THE USE OF HY-600 TRANSIT COATING REMOVER IN A HAND WASH OPERATION

Material Required: One bottle (0.8 L) of transit coating remover per vehicle
Equipment Required: Bucket, wash mitt, safety glasses, rubber boots and glove, hose.
The removal operation should be performed in a well ventilated and shaded area to prevent rapid evaporation of the remover solution and to reduce the likelihood of water spotting on the completed vehicle. The area must have drainage facilities and be located away from grass and plants biodegradable. The removal steps for transit coating are as follows;

Note : Do not allow the remover to dry. Continuously agitate the vehicle surface during the removal process (approximately 1-2 minutes) in order to prevent surface drying.
Notice :

3. STORAGE AND MAINTENANCE OF NEW VEHICLE IN EXTREMELY HOT AND HUMID LOCATIONS

DESCRIPTION:

The protection and maintenance of new vehicles awaiting delivery to customer are the exclusive responsibility of distributor. Regular maintenance is necessary to prevent rust formation or environmental damage. Given belows are the minimum maintenance guideline to be required during storage of new vehicles in extremely hot and humid locations.

Note : Such touch up are to be considered as the distributor normal pre-delivery responsibility.

Caution : If the ultrasonic interior space protection system is installed in the vehicle, keep the follows.



uzw2471b
Display graphicTranslations of text in graphics



uzw2471c
Display graphicTranslations of text in graphics


Keep the all windows open at a week intervals.
Open four windows fully

Note : Repeat this operation at least once a week while the vehicle is in storage and shift all steps of transmission during engine running.

uzw3111a
Display graphicTranslations of text in graphics



uzw3121a
Display graphicTranslations of text in graphics



uzw6031c
Display graphicTranslations of text in graphics



pdisec07p7
Display graphicTranslations of text in graphics



uzw2471d
Display graphicTranslations of text in graphics


The canopy may collapse due to heavy snow, resulting in the vehicle damage.
EXAMPLE OF CANOPY

pdisec07p8
Display graphicTranslations of text in graphics



pdisec07p9
Display graphicTranslations of text in graphics


To Previous PageTo Next Page


© Copyright Chevrolet Europe. All rights reserved