To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Input Speed Sensor Replacement

Removal Procedure
  1. Remove the transmission control valve body cover. Refer to Control Valve Body Cover Replacement .

    2. 1998829
  2. Disconnect the input speed sensor electrical connector (1).

    3. 1998841
  3. Remove the input speed sensor bolt (2) M6 x 23.
  4. Remove the input speed sensor (3).
  5. Remove the 3 input speed sensor seals (1).

Installation Procedure

    1998841
  1. Install the 3 input speed sensor seals (1).
  2. Install the input speed sensor (3).

    3. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the input speed sensor bolt (2) M6 x 23 and tighten to 12 N·m (106 lb in).

    4. 1998829
  4. Connect the input speed sensor electrical connector (1).
  5. Install the transmission control valve body cover. Refer to Control Valve Body Cover Replacement .

    6. Perform the service fast learn adapt procedure. Refer to Service Fast Learn Adapts .

   


© Copyright Chevrolet. All rights reserved