To the top of the document
Captiva
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Camshaft Cover Assemble

Special Tools

    • DT 5590 Bearing and Seal Driver
    • EN 24254-A Oil Seal Installer

For equivalent regional tools, refer to Special Tools .

Left Camshaft Cover


    1992540
  1. Install the NEW left spark plug shield tube seals using the DT 5590 driver (1) and EN 24254-A installer (2).

  2. 1992532
  3. Install the NEW left camshaft cover gasket.

  4. 2403568
  5. Install the oil filler tube (3) and oil filler tube O-ring (4) if a NEW camshaft cover and oil filler tube are being assembled. Lightly lubricate the O-ring with engine oil before inserting the oil filler tube into the camshaft cover. Make sure the tube is fully seated into both retaining tangs.
  6. Install the oil filler cap (1) and NEW O-ring (2).
  7. Caution: Refer to Fastener Caution in the Preface section.


    2403560
  8. Install the fuel injector sight shield cover ball stud (1) and tighten to 10 N·m (89 lb in).

  9. 2403551

    Note: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

  10. Install the NEW left camshaft cover bolt grommets (1).

Right Camshaft Cover


    1836411
  1. Install the NEW right spark plug shield tube coil seals using the DT 5590 driver (1) and EN 24254-A installer (2).

  2. 1833744
  3. Install the NEW right camshaft cover gasket.

  4. 1836419

    Note: The camshaft cover bolt grommet must be installed into the camshaft cover bolt hole before installing the camshaft cover bolt.

  5. Install the NEW right camshaft cover bolt grommets.
   


© Copyright Chevrolet. All rights reserved