To the top of the document
Aveo
To Previous Page To Next Page
GMDE Start Page Load static TOC Load dynamic TOC Help?

SECTION 9C

HORN

Caution : Disconnect the negative battery cable before removing or installing any electrical unit or when a tool or equipment could easily come in contact with exposed electrical terminals. Disconnecting this cable will help prevent personal injury and damage to the vehicle. The ignition must also be in LOCK unless otherwise noted.

SPECIFICATIONS

Fastener Tightening Specifications

Application
N•m
Lb-Ft
Lb-In
Horn Bolt
21
16
-

SCHEMATIC AND ROUTING DIAGRAMS

Horn, Power Jack, Ashtray Lamp & Cigar Lighter Circuit - Notchback -


T8B19C01
Display graphicTranslations of text in graphics


Horn, Power Jack, Ashtray Lamp & Cigar Lighter Circuit - Hatchback -


T8B19C02
Display graphicTranslations of text in graphics


MAINTENANCE AND REPAIR

ON-VEHICLE SERVICE


S6B19C01
Display graphicTranslations of text in graphics


Horn

Removal Procedure

  1. Disconnect the negative battery cable.
  2. Remove the headlamp mounting bolts.
  3. Disconnect the electrical connectors.
  4. Remove the headlamp assembly.
  5. Remove the bolt from the horn.
  6. Disconnect the electrical connector.
  7. Remove the horn.

S6B19C01
Display graphicTranslations of text in graphics


Installation Procedure

  1. Connect the electrical connector.
  2. Install the horn with the bolt.

    3. Tighten
    Tighten the horn bolt to 21 N•m (16 lb-ft).

  3. Connect the headlamp electrical connectors.
  4. Install the headlamp assembly with belts.

    5. Tighten
    Tighten the headlamp assembly bolts to 4 N•m (35 lb-in).

  5. Connect the negative battery cable.

GENERAL DESCRIPTION AND SYSTEM OPERATION

Horn

The horn is located under the hood. It is attached near the radiator at the front of the vehicle. The horn is actuated by pressing the steering wheel pad, which grounds the horn's electrical circuit.


To Previous Page To Next Page
© Copyright Chevrolet Europe. All rights reserved