Cruze

Power Mirror Folding Malfunction

The outside mirror switch controls the power folding or power extending functions of the outside rearview mirrors. The folding mirror motors are controlled by using bi-directional motor controls through the folding mirror motor retract control circuit and the folding mirror motor extend control circuit.

Schematic Reference

Outside Rearview Mirror Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Outside Mirror Description and Operation

Electrical Information Reference

Ignition ON, operate the mirror switch to the fold and extend positions. The outside rearview mirrors should fold and extend.

1. Ignition OFF, disconnect the harness connector at the appropriate A9 outside rearview mirror.
2. Connect a test lamp between control circuit terminal D and control circuit terminal E.
3. Operate the mirror switch to the fold and extend positions. The test lamp should turn ON for 1 second when commanding the fold and extend states.

⇒	If the test lamp remains OFF during either of the commands, test for a short to voltage, short to ground, or an open/high resistance on either control circuit. If the circuits test normal, replace the S52 outside mirror switch.

4. If all circuits test normal, test or replace the A9 outside rearview mirror.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.