Cruze

Fuel Hose Replacement - Fuel Injection Pump to Fuel Feed Block

Warning: Petrol or petrol vapours are highly flammable. A fire could occur if an ignition source is present. Never drain or store petrol or diesel fuel in an open container, due to the possibility of fire or explosion. Have a dry chemical (Class B) fire extinguisher nearby.

1. Remove the engine cover. Refer to Engine Cover Replacement .
2. Remove the air cleaner outlet front duct. Refer to Air Cleaner Outlet Front Duct Replacement .




Note: To avoid fuel spillage or damage to the injector pipe connector, hold the injector pipe connector using tools and unscrew the pipe nut. And then, put a cap on the injector connector to avoid contamination from dust as soon as the fuel pipes are removed.

3. Hold the injection pump pipe connector with a spanner (1) and unscrew the fuel hose nut (M14) from the fuel injection pump.



4. Remove the fuel hose nut (3) from the fuel feed block (2).
5. Remove the fuel hose bolt (5) from the thermostat housing.
6. Remove the fuel hose (4).

1. Install the fuel hose (4).
2. Install the fuel hose nut (6) at the fuel injection pump (1).

Caution: Refer to Fastener Caution in the Preface section.

3. Install the fuel hose nut (3) at the fuel feed block (2) and tighten to 20 N·m (15 lb ft).
4. Install the fuel hose bolt (5) at the thermostat housing and tighten to 20 N·m (15 lb ft).



5. Hold the injection pump pipe connector with a spanner (1) and tighten the fuel hose nut at the Fuel injection pump to 20 N·m (15 lb ft).
6. Install the air cleaner outlet front duct. Refer to Air Cleaner Outlet Front Duct Replacement .
7. Install the engine cover. Refer to Engine Cover Replacement .