Cruze

DTC B3697

The sunroof glass is controlled by its own integrated motor/controller containing the necessary electronics, motor, hall effect position sensors, as well as the interface to the driver control switches. The motor/controller is capable of controlling motion based on control switch activation and LIN-Bus message commands from the body control module (BCM).

The ignition is ON.

B3697 00

The sunroof module has detected and reported via the LIN-Bus that the sunroof actuator has a malfunction.

B3697 39

The sunroof module has detected and reported via the LIN-Bus that the sunroof actuator has a internal malfunction.

B3697 42

The sunroof module has detected and reported via the LIN-Bus that the sunroof actuator is not programmed.

B3697 4B

The sunroof module has detected and reported via the LIN-Bus that the sunroof actuator calibration is not learned.

DTC B3697 is stored in the BCM memory.

The BCM no longer detects a malfunction in the sunroof actuator.

Schematic Reference

Sunroof Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Sunroof Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

1. Verify that DTC B3697 42 or DTC B3697 4B is not set.

⇒	If the DTC is set, program or calibrate the K61 sunroof control module. If the DTC resets, replace the K61 sunroof control module.

2. Replace the K61 sunroof control module.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for sunroof motor/actuator replacement, programming and setup