Cruze

Mode Valve Gear Replacement — Left Hand Drive

1. Remove instrument panel assembly. Refer to Instrument Panel Assembly Replacement .



2. Remove instrument panel wiring harness (2) from instrument panel tie bar (1).

Disconnect electrical connectors.




3. Remove instrument panel tie bar (2).

•	Remove 4 instrument panel tie bar bolts (3, 4).

•	Remove 2 instrument panel tie bar nuts (1).




4. Remove mode control cam (1).



5. Remove 2 mode valve gear (1).

1. Install 2 mode valve gear (1).




Note: The mode valve gear can only be fitted in one position. The mode valve gears have to be fitted to the according mode valve levers in figured position. The ventilation dampers have to be in middle position.

2. Make sure that mode valve gears of mode valve levers (1) are fitted as shown in graphic above.




Note: The mode control cam can only be fitted in one position.

3. Install mode control cam (1).

Caution: Refer to Fastener Caution in the Preface section.




4. Install instrument panel tie bar (2).

•	Install 4 instrument panel tie bar bolts (3, 4) and tighten to 22 N·m (17 lb ft).

•	Install 2 instrument panel tie bar nuts (1) and tighten to 9 N·m (80 lb in).




5. Install instrument panel wiring harness (2) from instrument panel tie bar (1).

Connect electrical connectors.

6. Install instrument panel assembly. Refer to Instrument Panel Assembly Replacement .