Cruze

Front Hinge Pillar Body Sectioning — MAG-Welding

Note : According to different corrosion warranties, only the regional mandatory joining methods are allowed.

Warning : Refer to Approved Equipment for Collision Repair Warning in the Preface section.

Warning : Refer to Collision Sectioning Warning in the Preface section.

Warning : Refer to Glass and Sheet Metal Handling Warning in the Preface section.

1. Disable the SIR System. Refer to SIR Disabling and Enabling .
2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
3. Remove all related panels and components.
4. Visually inspect the damage. Repair as much of the damage as possible.
5. Remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair : Base .



6. Create cut lines on the front hinge pillar body.




Note : Do not damage any inner panels or reinforcements.

7. Cut the panel where sectioning is to be performed.



8. Locate and mark all the necessary factory welds of the front hinge pillar body.
9. Drill all factory welds. Note the number and location of welds for installation of the service assembly.



10. Remove the damaged front hinge pillar body.

1. Cut the front hinge pillar body in corresponding locations to fit the remaining original panel. The sectioning joint should be trimmed to allow a gap of one-and-one-half-times the metal thickness at the sectioning joint.
2. Create a 50 mm (2 in) backing plate from the unused portion of the service part.
3. Drill 8 mm (5/16 in) along the sectioning cut on the remaining original part. Locate these holes 13 mm (1/2 in) from the edge of part and spaced 40 mm (1½ in) apart.
4. Prepare all mating surfaces as necessary.
5. Fit the backing plates halfway into the sectioning joints, clamp in place and plug weld to the vehicle.
6. Align the front hinge pillar body.



7. Drill 8 mm (5/16 in) for plug welding along the edges of the front hinge pillar body as noted from the original panel.
8. Clean and prepare the attaching surfaces for welding.



9. Position the front hinge pillar body on the vehicle.
10. Verify the fit of the front hinge pillar body.
11. Clamp the front hinge pillar body into position.



12. Plug weld accordingly.
13. To create a solid weld with minimum heat distortion, make 25 mm (1 in) stitch welds along the seam with 25 mm (1 in) gaps between them. Then go back and complete the stitch weld.
14. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair : Base .
15. Paint the repaired area. Refer to Basecoat/Clearcoat Paint Systems .
16. Install all related panels and components.
17. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
18. Enable the SIR system. Refer to SIR Disabling and Enabling .