To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Automatic Transmission Flex Plate Replacement

Special Tools

    • EN-470-B Angular Torque Wrench
    • EN-652 Flywheel Holder

For equivalent regional tools, refer to Special Tools .

Removal Procedure
  1. Open bonnet.
  2. Remove the automatic transmission. Refer to Transmission Replacement : 2.0L Diesel LNP → 1.6L LXT, L2W, LDE and 1.8L 2H0 → 2.0L Diesel LLW .

    3. 2191962
  3. Install EN-652 flywheel holder (1) in order to fix the automatic transmission flex plate (2).

    4. 2191963
  4. Remove and DISCARD the 6 automatic transmission flex plate bolts (2).
  5. Remove the automatic transmission flex plate (1).

Installation Procedure
  1. Clean the 6 screw bores. Rework if necessary.

    2. 2191963
  2. Install the automatic transmission flex plate (1).
  3. Install 6 NEW automatic transmission flex plate bolts (2).

    4. 2191962
  4. Install EN-652 flywheel holder (1) in order to fix the automatic transmission flex plate (2).

    5. Caution: Refer to Fastener Caution in the Preface section.

    Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.

  5. Tighten the 6 automatic transmission flex plate bolts in a cross sequence to 35 N·m(26 lb ft).
  6. Tighten the 6 automatic transmission flex plate bolts in a cross sequence to an additional 30°.Use EN-470-B wrench .
  7. Tighten the 6 automatic transmission flex plate bolts in a cross sequence to an additional 15°.Use EN-470-B wrench .
  8. Install automatic transmission. Refer to Transmission Replacement : 2.0L Diesel LNP → 1.6L LXT, L2W, LDE and 1.8L 2H0 → 2.0L Diesel LLW .
  9. Close the bonnet.
   


© Copyright Chevrolet. All rights reserved