To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

DTC P1761

Diagnostic Instructions
    • Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
    • Review Strategy Based Diagnosis for an overview of the diagnostic approach.
    • Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P1761: Up and Down Shift Switch Signal Message Counter Incorrect

Circuit/System Description

A 12 volt signal circuit is provided by the body control module (BCM) to the plus or minus buttons. When a plus or minus button is pressed, a corresponding voltage drop occurs across the resistor network embedded in the switches. This voltage drop is monitored by the BCM. The BCM will send the request to the transmission control module (TCM) to perform the upshift or downshift. The TCM is constantly monitoring the serial data sent from the BCM for the correct number and sequence of counts for Tap Up and Tap Down function.

Conditions for Running the DTC

The engine speed is greater than 400 RPM for 5 seconds.

Conditions for Setting the DTC

The TCM detects the serial data rolling count value for the Tap Up/Tap Down does not match with the expected BCM count, 3 or greater times in 10 seconds.

Action Taken When the DTC Sets
    • DTC P1761 is a Type C DTC.
    • The TCM inhibits the Tap Up/Tap Down function.
    • The TCM inhibits manual shifting of forward gears.

Conditions for Clearing the DTC

DTC P1761 is a Type C DTC.

Reference Information

Description and Operation

Electronic Component Description for control solenoid valve assembly information.

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification
  1. DTC P1761 is an informational DTC. Diagnose all other BCM DTCs prior to DTC P1761. Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
  2. If there are no other body control DTCs, diagnosis is accomplished by looking for an intermittent CAN circuit fault. Refer to Scan Tool Does Not Communicate with High Speed GMLAN Device .
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

    • Control Module References for BCM and control solenoid valve assembly replacement, set-up, and programming.
    • Perform the Transmission Adaptive Values Learn following all transmission related repairs.
   


© Copyright Chevrolet. All rights reserved