Service Information

Cruze

DTC P0575

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptor

DTC P0575: Cruise Control Switch Signal Message Counter Incorrect

When a cruise control function switch is activated, the body control module (BCM) detects a predetermined voltage. The BCM sends a serial data message to the engine control module (ECM) indicating the function that has been requested.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

•	The ECM receives an invalid cruise control switch status serial data message from the BCM.

•	This diagnostic runs continuously.

Action Taken When the DTC Sets

DTC P0575 is a type C DTC.

Conditions for Clearing the DTC

DTC P0575 is a type C DTC.

Reference Information

Electrical Information Reference

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

Circuit/System Verification

Verify that DTC B3794 is not set.

⇒	If DTC is set, refer to DTC B3794 .

Road test the vehicle and attempt to engage cruise control. Verify that cruise control engages properly and the DTC P0575 is not set.

⇒	If DTC is set, replace the K9 Body Control Module. Clear the DTC, road test the vehicle and attempt to engage cruise control. If the DTC resets, replace the K20 Engine Control Module.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for control module replacement, set-up and programming