To the top of the document
Cruze
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Crankshaft Position Sensor Replacement

Removal Procedure
  1. Remove the front compartment insulator. Refer to Front Compartment Insulator Replacement .
  2. Disconnect the crankshaft position sensor wiring harness plug.

    3. 2512643
  3. Remove the crankshaft position sensor bolt (2).
  4. Remove the crankshaft position sensor (1).

Installation Procedure

    2512643
  1. Install the crankshaft position sensor (1).

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the crankshaft position sensor bolt (2) and tighten to 10 N·m (89 lb in).
  3. Connect the crankshaft position sensor wiring harness plug.
  4. Install the front compartment insulator. Refer to Front Compartment Insulator Replacement .
   


© Copyright Chevrolet. All rights reserved