Service Information

Orlando

2-6 Clutch Piston Installation - 6T40/45/50

Callout

Component Name

2-6 Clutch Piston Assembly

Tip

•	Position the 2-6 piston air bleed and large slot toward the top of the case.

•	DT-47796 seal protector prevents the piston seal lip from damage during installation. Apply a thin coat of ATF to the I.D. of the DT-47796 seal protector to ease installation of the piston.

DT-47796 Seal Protector

For equivalent regional tools, refer to Special Tools .

2-6 Clutch Spring

2-6 Clutch Spring Retainer

Caution: Regulate the air pressure to 276 kPa (40 psi) maximum. High pressure could cause the piston to over travel and damage the piston seals.

Tip

•	Place the retainer on the 2-6 clutch spring and align the retainer opening with the largest gap in the case splines toward the bottom of the case. The retainer opening should be supported by a spline tooth of the case.

•	Apply shop air to the clutch fluid feed hole in the case to verify proper piston operation.

•	DT-47797 Spring Installer

•	DT-48056 Spring Compressor Bridge

For equivalent regional tools, refer to Special Tools .