Preliminary Procedures

Remove the control solenoid valve and the transmission control module assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly Replacement .

1

Fluid Level Control Valve

2

Fluid Level Control Valve Gasket

Procedure

DISCARD the gasket. Use a NEW gasket only.

3

Control Valve Body Bolt M6 x 60 (Qty: 9)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Tighten in specified sequence.

Tighten
12 N·m (106 lb in)

4

Control Valve Body Bolt M6 x 53 (Qty: 2)

Procedure

Tighten in specified sequence.

Tighten
12 N·m (106 lb in)

5

Control Valve Body Assembly

Procedure

1. After repairs, refer to Control Module References for programming and set up procedures.
2. Perform the transmission adaptive values learn. Refer to Transmission Adaptive Values Learn .

6

Control Valve Body Spacer Plate Assembly

7

Manual Shaft Detent Spring Bolt M6 x 16 (Qty: 1)

Tighten
12 N·m (106 lb in)

8

Manual Shaft Detent Lever Spring Assembly

9

1-2-3-4 Clutch Fluid Passage Seal

Procedure

DISCARD the seal. Use a seal NEW seal only.

10

Low/Reverse Clutch Fluid Passage Seal

Procedure

DISCARD the seal. Use a seal NEW seal only.