DTC B101E
Diagnostic Instructions
DTC Descriptor
DTC B101E 00: Electronic Control Unit Software
DTC B101E 31: Electronic Control Unit Software Internal Checksum Error
DTC B101E 32: Electronic Control Unit Software General Memory Malfunction
DTC B101E 41: Electronic Control Unit Software Not Programmed
DTC B101E 42: Electronic Control Unit Software Calibration Not Programmed
DTC B101E 43: Electronic Control Unit Software EEPROM Incorrect Programming
DTC B101E 44: Electronic Control Unit Software Security Access Not Activated
DTC B101E 45: Electronic Control Unit Software Variant Not Programmed
DTC B101E 46: Electronic Control Unit Software Configuration Not Programmed
DTC B101E 47: Electronic Control Unit Software VIN Not Programmed
DTC B101E 48: Electronic Control Unit Software Security Code Not Programmed
DTC B101E 4A: Electronic Control Unit Software Programming Checksum Error
DTC B101E 4B: Electronic Control Unit Software Calibration Not Learned
DTC B101E 4C: Electronic Control Unit Software DTC Memory Full
Circuit/System Description
Some control modules must be configured with specific software, serial numbers, vehicle options, or other information. If a control module was not properly configured after installation that module may set DTC B101E. The symptom byte listed in the DTC Descriptor is for engineering reference only. No external circuit diagnosis is involved.
Conditions for Running the DTC
Battery voltage is between 9-16 V and data link communications operate normally.
Conditions for Setting the DTC
The control module is not configured properly.
Conditions for Clearing the DTC
| • | A current DTC clears when the malfunction is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction. |
Reference Information
Schematic Reference
Data Communication Schematics
Connector End View Reference
Component Connector End Views
Description and Operation
Data Link Communications Description and Operation
Electrical Information Reference
Scan Tool References
Control Module References for scan tool information
Circuit/System Verification
Verify DTC B101E is not set.
| ⇒ | If the DTC is set, program the control module. If the DTC resets, replace the control module. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for control module replacement, setup, and programming
| © Copyright Chevrolet. All rights reserved |
| © Copyright Chevrolet. All rights reserved |
