Orlando

Crankshaft Balancer Installation

Special Tools

For equivalent regional tools, refer to Special Tools .

1. Install the EN-652 holder (1), lock the flywheel (2) or the automatic transmission flex plate via the starter ring gear.

Caution: Refer to Fastener Caution in the Preface section.

Caution: Refer to Torque-to-Yield Fastener Caution in the Preface section.




2. Install the crankshaft balancer (2) and a NEW bolt (1) and tighten in 3 passes using the EN-45059 sensor kit :

2.1.	First pass to 95 N·m (70 lb ft)

2.2.	Second pass to 45°.

2.3.	Third pass to 15°.