Service Information

Orlando

Adding Keys

The Adding Keys procedure does not erase any keys prior to programming. The procedure will simply program the key into the next available slot. The Adding Keys procedure should only be used when adding an additional key to the vehicle. The Adding Keys procedure should never be used to program a key to a vehicle that is having a key replaced, regardless of the cause for the replacement.

Adding Keys - without BTM

Note:

•	This procedure may be used with or without existing learned keys being present.

•	This procedure will take more than 15 minutes to complete.

•	A total of 8 keys maybe be learned to a single vehicle.

•	This procedure will only learn the vehicle key information. This procedure will not learn any immobiliser information between the body control module (BCM) and engine control module (ECM).

•	If the battery voltage is low, charge the battery before continuing with the procedure.

Connect a scan tool to the vehicle and access SPS. Refer to.
Ensure that all power consuming devices are turned OFF on the vehicle.
Select the SPS application and follow the onscreen instructions.
Select Reprogram ECU.
Select IMMO Immobiliser Learn.
Select the Program Transponder or Remote Key function.
Follow the on-screen instructions.
With a scan tool, clear any DTCs.

Adding Keys - with BTM

Note:

•	This procedure may be used with or without existing learned keys being present.

•	This procedure will take more than 15 minutes to complete.

•	A total of 8 keys maybe be learned to a single vehicle.

•	This procedure will only learn the vehicle key information. This procedure will not learn any immobiliser information between the body control module (BCM) and engine control module (ECM).

•	If the battery voltage is low, charge the battery before continuing with the procedure.

Connect a scan tool to the vehicle and access SPS. Refer to.
Ensure that all power consuming devices are turned OFF on the vehicle.
Select the SPS application and follow the onscreen instructions.
Select Reprogram ECU.
Select IMMO Immobiliser Learn.
Select the Program Transponder & Remote Key function.

Note:

•	At multiple times during the learn procedure, SPS will instruct you to turn the ignition to the run position. Make sure the vehicle is actually in the run mode before continuing on the SPS terminal. If the igniting is not in the run mode, the learn procedure will fail.

•	The key slot is located inside the centre console storage area. To access the slot, remove the circular cover at the bottom of the storage area with a pick tool. Insert the key into the exposed key slot.

Follow the on-screen instructions.
After the SPS procedure has completed, press and hold the ignition mode switch for 15 seconds.
With a scan tool, clear any DTCs.