Orlando

Odometer Trip/Reset Switch Inoperative

The instrument cluster displays the travelled distance based on the information from the engine control module (ECM). The ECM converts the data from the vehicle speed sensor to a distance signal. The ECM sends the distance information via a High Speed CAN-Bus signal to the body control module (BCM). The BCM then sends the information via a Low Speed CAN-Bus signal to the instrument cluster to display the vehicle odometer and trip odometer. The instrument cluster detects the activation of the trip reset switch and a press and hold of the trip reset switch resets the trip odometer information to zero.

Schematic Reference

Instrument Cluster Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Instrument Cluster Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

Ignition ON, verify the odometer trip reset switch resets the trip odometer display when the switch is pressed.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for instrument cluster replacement, setup, and programming