DTC P2299
Diagnostic Instructions
DTC Descriptor
DTC P2299 00: Brake Pedal Position - Accelerator Pedal Position Not Plausible
Circuit/System Description
The brake pedal position is a variable input to the controller based on the brake pedal being applied or released. The accelerator pedal position is a variable input to the controller based on the accelerator pedal being applied or released
Conditions for Running the DTC
| • | The ignition is ON or the engine is running. |
| • | The DTC runs continue once the above conditions are met. |
Conditions for Setting the DTC
The engine control module (ECM) detects that the accelerator pedal and the brake were actuated simultaneously, or the accelerator pedal was actuated before the brake.
Action Taken When the DTC Sets
DTC P2299 5A is a Type B DTC.
Conditions for Clearing the DTC
DTC P2299 5A is a Type B DTC.
Reference Information
Schematic Reference
Engine Controls Schematics
Connector End View Reference
Component Connector End Views
Electrical Information Reference
DTC Type Reference
Control Module References for scan tool information
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Ignition ON, observe the DTC information with a scan tool. Verify that DTC P2122, P2123, P2127, P2128 or P2138 are not set.
| ⇒ | If any of the DTCs are set, refer to
DTC P2122, P2123, P2127, P2128, or P2138 : LNP or LNQ for further diagnosis. |
- Verify correct brake lamp operation.
- DTC P2299 00 is an informational DTC. If there are other Engine Controls DTCs, refer to Diagnostic Trouble Code (DTC) List - Vehicle for further diagnosis.
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| © Copyright Chevrolet. All rights reserved |
| © Copyright Chevrolet. All rights reserved |
