Preliminary Procedures

1. Remove control lever knob. Refer to Transmission Control Lever Knob Replacement .
2. Remove instrument panel centre moulding. Refer to Instrument Panel Centre Moulding Replacement .

1

Transmission Control Bolt (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

1. Unclip wiring harness and disconnect electrical connector transmission control.
2. Disconnect range selector lever cable from transmission control. Refer to Range Selector Lever Cable Replacement .
3. Adjust range selector lever cable. Refer to Range Selector Lever Cable Adjustment .

Tighten
9 N·m (80 lb in)

2

Transmission Control