Orlando

Headlamp Levelling Malfunction

Each headlamp assembly contains a headlamp levelling motor that is controlled by the headlamp switch. The headlamp switch is a resistance ladder switch and wired to each headlamp levelling motor. With the ignition in ON position the headlamp switch and each headlamp levelling motor is applied to B+. Each headlamp levelling motor is permanently grounded.

Schematic Reference

Headlamps/Daytime Running Lamps (DRL) Schematics

Connector End View Reference

Component Connector End Views

Description and Operation

Exterior Lighting Systems Description and Operation

Electrical Information Reference

Scan Tool Reference

Control Module References for scan tool information

Ignition ON, cycle the headlamp levelling switch in each position while observing both headlamps. Both headlamps should operate to the appropriate position when commanded.

1. Ignition OFF, disconnect the harness connector at the headlight assembly listed below.

⇒	M29L Headlight Levelling Actuator - Left

⇒	M29R Headlight Levelling Actuator - Right

2. Ignition OFF, test for less than 5 Ω between the ground circuit terminal 3 and ground.

⇒	If greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, connect a test lamp between the ignition circuit terminal 1 and ground. The test lamp should illuminate.

⇒	If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.

4. Ignition OFF, disconnect the harness connector at the S30 Headlamp Switch.
5. Ignition ON, connect a test lamp between the ignition circuit terminal 9 and ground. The test lamp should illuminate.

⇒	If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.

6. Ignition ON, test for less than 0.3 V between the signal circuit terminal 10 and ground.

⇒	If greater than the specified range, test the signal circuit for a short to voltage.

7. Ignition OFF, test for greater than 500 kΩ between the signal circuit terminal 10 and ground.

⇒	If less than the specified range, test the signal circuit for a short to ground.

8. Ignition OFF, test for less than 5 Ω between the signal circuit terminal 10 at the S30 Headlamp Switch and the control circuit terminal 2 at the appropriate headlamp assembly.

⇒	If greater than the specified range, test the signal circuit for an open/high resistance.

9. Ignition OFF, reconnect the harness connector at the S30 Headlamp Switch.
10. Ignition ON, test for 4.5-11.5 V between the control circuit terminal 8 at the appropriate headlamp assembly and ground. Switch the headlamp leveling switch in each position, the voltage should change in each position.

⇒	If the voltage does not change, replace the S30 Headlight Switch.

11. If all circuits test normal, replace the appropriate headlamp assembly.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.