Orlando

DTC P242B - LNP or LNQ

The exhaust gas temperature sensors are variable resistors that measure the temperature of the exhaust gas. The exhaust gas temperature sensor 1 is located in the exhaust manifold before the turbocharger. The exhaust gas temperature 2 sensor is located in the exhaust pipe after the turbocharger. The exhaust gas temperature 3 sensor is located in the exhaust gas particle filter. The engine control module (ECM) supplies 5 V to the exhaust gas temperature signal circuit and supplies a ground to the low reference circuit. The exhaust gas temperature sensor temperature information is used by the ECM during the exhaust gas particulate filter cleaning process.

The following table illustrates the difference between temperature, resistance, and voltage:

P242B

The ECM detects that the exhaust gas temperature sensor is less than 0.1 V for greater than 1 s or the exhaust gas temperature sensor is greater than 4.9 V for greater than 1 s.

DTCs P242B 00 is a Type A DTC.

DTCs P242B 00 is a Type A DTC.

Schematic Reference

Engine Controls Schematics

Connector End View Reference

Component Connector End Views

Electrical Information Reference

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions

Scan Tool Reference

Control Module References for scan tool information

1. Engine running, observe the DTC information with a scan tool. DTCs P242C 00, or P242D 00 should not set.
2. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure records data.

1. Ignition OFF, disconnect the harness connector at the B131C Exhaust Temperature Sensor 3.
2. Test for less than 5 Ω between the low reference circuit terminal 2 and ground.

⇒	If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K20 Engine Control Module.

3. Ignition ON, verify the scan tool Exhaust Gas Temperature Sensor 3 parameter is at 900°C (1 653°F).

⇒	If less than the specified range, test the signal circuit for a short to ground. If the circuit tests normal, replace the K20 Engine Control Module.

Note: If the fuse in the jumper wire opens, the signal circuit is shorted to a voltage and the sensor may be damaged.

4. Install a 3 A fused jumper wire between the signal circuit terminal 1 and ground. Verify the scan tool Exhaust Gas Temperature Sensor 3 parameter is at -40°C (-40°F).

⇒	If greater than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K20 Engine Control Module.

5. If all circuits test normal, test or replace the B131C Exhaust Temperature Sensor 3.

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.