Service Information

Orlando

Sunroof Control Module Programming and Setup - Existing Motor

Perform the Programming and Setup Process for the sunroof window any time a new sunroof window motor actuator is installed in the vehicle.

"Manual" indicates the first switch detent.

"Express" indicates the second switch detent.

Ensure that the electrical harness on the headliner is connected to the sunroof motor.
Put the ignition in the RUN position. (CAL file will be automatically downloaded by Body Control housing, BCM).

"Manual close" is allowed and limited "manual open" is allowed.

Re-initialisation (Normalisation), ensure that the sunroof window is in the fully closed position.
Press "Manual Close Switch and hold for more then 10 seconds, do Not release the switch, at this time the sunroof window will automatically begin to move to the fully Close position.
Do Not release the switch until the window finds the hard stop and move sightly back.
Learn:

6.1.	Open the sunroof window with the express or manual open the switch to the full open position the release the switch.

6.2.	Press "Manual Open Switch and hold for more then 10 seconds, do Not release the switch, at this time the sunroof window will automatically begin to move to the fully Close position.

During this time it is necessary to keep the switch active until the process completes.

Note: The Programming and Setup Process is not complete if any of the following actions take place before the initialisation cycle is done:

•	The sunroof window switch is not held in the close position.

•	The ignition and/or battery power has been removed.

•	The window panel has not reached the closed position.

The Programming and Setup Process must be restarted if the procedure is not carried out completely.