SECTION 6
APPEARANCE
1. INSPECT CONDITION AND PERFORM DETAIL OPERATION
- Remove exterior protective shipping material(s), and check that protective shipping material should be completely removed. The removal operation should be performed as the attached directions.
- Wash vehicle.
- Check the washing condition of vehicle.
- If required, perform the following steps to insure exterior washing.
- – Rinse the loose dirt from the vehicle with a fine spray or water.
- – Wash the vehicle using a sponge and water mixed with a mild detergent.
- – Rinse the soap with a fine spray of water.
- – Rinse the vehicle completely with water.
- – Wipe the vehicle dry from top to bottom using a clean chamois or soft, absorbent towel.
2. CHECK FOR PROPER ASSEMBLY, FIT AND RETENTION OF PARTS AND COMPONENTS
Check for proper assembly, fit and retention of following parts and component.
- – Bumpers
- – Moldings
- – Grille
- – Sill plates
- – Emblems
- – Mud guard
- – Roof rack(option)
3. EXTERIOR FINISH
Check exterior and perform the remedial actions if defects are found, and then finish work is required as follows.
- – Detail clean up - remove over spray, cement, weatherstrip sealer, etc.
- – Touch up - chipped paint (brush or aerosol spray)
- – Hand polish - minor paint imperfections by wet sanding with 600-grit paper or hand compounding.
4. INTERIOR TRIM AND CARPETS PROTECTIVE COVERINGS
Inspect the followings clean, as required.
- – Instrument panel and sun visor.
- – Kick pads, seats and carpet.
- – Door trim panels, consoles and headliner.
- – Interior moldings and hard trim for fit, over spray, polish, sealer and adhesive clean as required.
- – Trunk trim.
5. SPARE WHEEL, JACK AND VEHICLE TOOLS
Check for the spare wheel, jack and vehicle tools which are accommodated in the luggage/load compartment. The spare wheel is retained by a bolt under a floor cover. The jack and vehicle tools are located at the very rear of spare wheel compartment.
DESCRIPTION |
Spare wheel Bag - Tool Wrench - Wheel nut Tool - Spanner Jack Jack Lever Tool - Driver |
6. BATTERY
Check the battery condition through the hydrometer(test indicator) in the top of the battery.
