To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Yazaki Connectors — 16-Way

Special Tools

    • EL-38125-550 Terminal Release Tool Kit
    • J-38125-215 Terminal Release Tool

For equivalent regional tools, refer to Special Tools .

Terminal Removal Procedure


    1709336
  1. While depressing the lock, pull the two connector halves apart.
  2. Note: The terminal position assurance (TPA) is fragile and may break if not done carefully.

  3. Use a small flat-blade tool to very carefully push the TPA toward the face of the connector on both sides of the connector.

  4. 1709329
  5. View of the male half of the connector with female terminals.

  6. 1709335
  7. View of the female half of the connector with male terminals.
  8. Use the J-38125-215 tool to release the terminals by inserting the tool into the terminal release cavity.

  9. 1709332
  10. View of the female half of the connector with male terminals.

  11. 1709331
  12. View of the male half of the connector with female terminals.
  13. While holding the removal tool in place, gently pull the wire out of the back of the connector. Always remember never use force when pulling a terminal out of a connector.
  14. Repair the terminal by following the Repairing Connector Terminals : Terminal Repair → Terminated Lead Repair procedure.
  15. Insert the repaired terminal back into the cavity. Repeat the diagnostic procedure to verify the repair and reconnect the connector bodies.
   


© Copyright Chevrolet. All rights reserved