To the top of the document
Spark
   
GMDE Start Page Load static TOC Load dynamic TOC Help?

Electronic Brake Control Module Replacement


2308677

Callout

Component Name

Warning: Refer to Brake Fluid Irritant Warning in the Preface section.

Caution: Always connect or disconnect the wiring harness connector from the EBCM/EBTCM with the ignition switch in the OFF position. Failure to observe this precaution could result in damage to the EBCM/EBTCM.

Preliminary Procedure

Remove the EBCM/BPMV assembly from the vehicle. Refer to Brake Pressure Modulator Valve Replacement .

1

Electronic Brake Control Module Bolt (Qty: 4)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
2.8 N·m (25 lb in)

2

Brake Pressure Modulator Valve

3

Electronic Brake Control Module

Procedure

  1. Separate the EBCM from the BPMV by carefully pulling apart. DO NOT pry the components apart.
  2. If a new EBCM is being installed, program the EBCM. Refer to Control Module References
   


© Copyright Chevrolet. All rights reserved